Starlink on an RV in Motion: What You Need
Using Starlink on an RV while driving: approved hardware, in-motion plans, permanent mounts, 12V power and typical installation costs.
A dish sitting on a picnic table works at camp. Using it while driving is different: you need hardware and a plan the provider allows for in-motion use, plus a permanent mount.
Mount options
Flat roof mounts with adhesive or bolted brackets are the most common in-motion choice. Ladder and pole mounts are for stationary use only.
Power
12V DC conversion cuts inverter losses and makes boondocking practical. Fuse every run and route cable through a sealed roof entry.
Roof care
Ask about your roof membrane (TPO, EPDM, fiberglass) and warranty before drilling. Use self-leveling sealant on any penetration.
Typical cost
$400–$900 for a stationary roof mount; $900–$1,900+ for in-motion setups with 12V power.
Frequently asked questions
Is in-motion use legal?
It's allowed with approved hardware and plans. The driver should never operate devices while driving, and the mount must be secure.
Can a van or truck use the same setup?
Often yes. See our truck & overland page.
Get matched with an installer
Tell us about the job and we'll match you with one independent local installer. Request free quotes.